Factory primer fails brickmold

Here is a very popular issue with new construction homes. The factory primer on brick molding and door jambs comes off regularly. There is no failsafe work around for this issue aside from stripping the lousy factory primer off.

Here are a few tips to help this troublesome problem along. Let’s face it; until enough builders complain about this issue, it won’t change. You can run a palm sander or orbital sander vigorously on all areas possible. These jambs are finger jointed and it is important to smooth up those joints and seal them better. Take some 150 grit sandpaper and knock off any sharp edges everywhere else. The paint will fail if you were to paint over these sharp edges.

Now, mix up some Zinsser Cover Stain at this formula. 32 oz. of Cover Stain to 12 oz. of NAPTHA and apply to the entire jamb. This diluted mixture will do three things 1) penetrate the finger-joints 2) soften factory primer and 3) penetrate factory primer to give some added bite. When dry, apply two heavy coats of your favorite acrylic finish.

See also: Sandpaper Time Savers

Advertisements

Tags: , , , , , , , , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s


%d bloggers like this: